CHAPTER 2.
Ошибка
!
Стиль
не
определен
.
2-256
© SAMSUNG Electronics Co., Ltd.
[724] DIAL NUMBERING PLAN
This MMC allows the technician to change directory numbers for stations, trunks, station
groups, trunk groups and feature access codes. The system can be pre-programmed with a
default three or four digit numbering for station, station groups and trunk numbers
depending on the position of the DIP switches on the MCP2 card. There is an error
message provided to prevent the accidental duplication of a directory number or feature
access code.
No
Type of Dial No
Description
00
STN DIAL NO.
This is where station directory numbers are changed or assigned.
Default: 201-2xx, 3xx(last 319) or 2001-2xxx
01
TRK DIAL NO.
This is where trunk directory numbers are changed or assigned.
Default: 701-7xx or 7001-7xxx
02
AA/VD DIAL NO
This is where AA port or Voice Dial port directory numbers are
changed or assigned.
Default: AA ports: 3951-39xx
VD ports: 3981-398x
03
MISC DIAL NO.
This is where directory numbers for relays, MOH ports and the
alarm sensor are changed or assigned.
Default: Internal CHIME: 371
Internal MODEM: 3999
External MOH: 372-377
External PAGE & Relay: 361-369
Common Bell Relay: 3991-3993
Loud Bell Relay: 3995-3997
04 STNG
DIAL
NUMBER
This is where station group numbers are changed or assigned.
Default: 500-5xx or 5001-5xxx
05 TRKG
DIAL
NUMBER
This is where trunk group numbers are changed or assigned.
Default: The first is 9 or 0, 800-828
06
FEAT DIAL NUMBER This is where feature access codes are changed or assigned.
Dialling codes are entered via the dial pad key by pressing the dial
pad number the required steps to select the feature. For example,
for OHVA, the number 6 would be pressed three times.
NOTE) Please remember that this program is system-wide.
07
S0 STN DIAL NO.
This is where directory numbers for BRI station ports mapping
terminal number.
Default: 8701-8748
08
DECT STN DIAL NO
This is where directory numbers for DECT terminals.
Default: 8801-8899
09
NTWK LCR DIAL NO
This is where additional LCR access codes are entered in the case
when two or more OfficeServ 500 system are networked together.
Default: NONE
