CHAPTER 2.
Ошибка
!
Стиль
не
определен
.
2-286
© SAMSUNG Electronics Co., Ltd.
[740] DECT SYSTEM CODE
Used to identify your DECT system and the handsets your register with your system.
The DECT system Code for your system is actually made up of two fields:
the System ID which is three hexadecimal digits in the range 000 to 999; and the Auth
Code(short for Authentication Code) which is four hexadecimal digits in the range 0000 to
9999. The default values are 000 and FFFF respectively.
The DECT System Code/Register handsets Change
Only the system administrator and/or installer should be allowed access to
change the DECT System Code and Register handsets.
CONDITIONS
y
You must use this MMC to change the default values for the values you have been
provided with by your supplier. If you do not change the defaults you will not be able
to register handsets.
y
Once you have entered your new System ID and Auth Code using this MMC you can
then begin registering your handsets with the Auth Code. The system checks the Auth
Code entered for each handset against the DECT Auth Code. If it is the same, the
registration procedure continues; otherwise, the system rejects the registration
procedure.
DEFAULT DATA
AUTH CODE: FFFF
SYSTEM ID: 000
ACTION DISPLAY
1) Press Transfer button and enter 740.
Display shows:
DECT SYSTEM CODE
AUTH CODE:FFFF
2) Dial 0 for AUTH code or 1 for system ID.
OR
DECT SYSTEM CODE
AUTH CODE:FFFF
Press Volume button to make a selection and
press Right Soft button to move cursor.
3) If option is AUTH code, enter AUTH CODE
via dial keypad.(e.g., 1234)
DECT SYSTEM CODE
AUTH CODE:1234
