OfficeServ 500 Programming Guide
© SAMSUNG Electronics Co., Ltd.
2-11
[105] STATION SPEED DIAL
Allows the system administrator or technician to program the personal speed dial locations
assigned to a station. This must be done for single line telephones because these stations
cannot access programming.
CONDITIONS
Each station may have up to 50 locations or bins assigned to it in MMC 606 Assign Speed
Block.
The speed dial bins are numbered 00~49. Each speed dial number consists of a trunk or
trunk group access code followed by a separator and up to 24 digits to be dial. These dial
digits may consist of 0~9, * and #. If the system recognizes a valid trunk or trunk group
access number, it will automatically insert the separator.
DEFAULT DATA
NONE
PROGRAM BUTTONS
B
Used to insert a flash code ‘F’
C
Used to insert a pause code ‘P’
D
Used to insert a pulse/tone conversion code ‘C’
E
Used to mask/unmask following digits(shows as ‘[’or ‘]’)
F
Used to enter name for speed dial bin(see MMC 106)
ACTION DISPLAY
1) Press Transfer button and enter 105.
Display shows:
[201] SPEED DIAL
00:
2) Dial
station
number.(e.g.,
205)
OR
[205] SPEED DIAL
00:
Press Volume button to select station and
press Right Soft button to move cursor.
If selected station has no speed dial bins,
the display will be as shown and a new station
[205] SPEED DIAL
SPDBLK NOT EXIST
may
be
selected.
3) Dial location number.(e.g., 05)
OR
[205] SPEED DIAL
05:_
Press Volume button to select location and
press Right Soft button to move cursor.
