OfficeServ 500
USER INSTRUCTIONS
TECHNICAL MANUAL
PART 1 MARCH 2004
1.11
1.7 PROGRAMMING PERSONAL SPEED DIAL
LOCATIONS
You can program frequently dialed telephone numbers in a personal speed dial list.
Each station user begins with ten numbers 00–09 and may be assigned up to fifty
numbers. See your system administrator to determine the amount assigned to your
station.
NOTE: Press button
B
for flash and button
C
for pause.
Display keyset users may want to hide some speed dial numbers so they will not show
in the display. Before entering a telephone number, press button
E
. All digits after this
will be hidden. Press button
E
again to begin displaying digits.
If your system uses rotary (or pulse) dialing C.O. lines, pressing button
D
before
entering a speed dial will cause all subsequent digits to be sent as DTMF tones until
the
D
button is pressed again.
ACTION
DISPLAY
1. Press
the
transfer key
followed by
105
Display shows
[201] SPEED DIAL
00:
If you have no speed dial bins,
the display will be as shown
[201] SPEED DIAL
SPDBLK NOT EXIST
2. Dial the location number (e.g.,
05
)
OR
[201] SPEED DIAL
05:_
Press
UP
or
DOWN
to select the location
Press the right soft key to move cursor
3. Enter the trunk access code (e.g.,
9
) followed
by the number to be dialed (e.g.,
4264100
)
[201] SPEED DIAL
05:9-4264100_
OR
Press the left soft key to return to step 2
4. Press
the
F
button to access the next program
OR
Press the
transfer key
to save and exit
Home Page
Table of Contents
