OfficeServ 7100
PROGRAMMING
TECHNICAL MANUAL
PART 2 MAY 2009
MMC: 831
•
PRIVATE w PUBLIC – the system knows that there is a mixture of ITP/VOIP
devices on the same network and on remote network(s), thus communicates
accordingly based upon the entries in MMC 840 (for ITP phones).
•
Public IP Only – use when MGI’s IP address is exposed to the public
network.
•
LOCAL RTP:
This defines the UDP port range the MGI card listens on. This
setting defines a range of 32 ports (i.e. 30000 means 30000~30031 etc.). The
port number entered is just defining the first of a 32 port range.
•
CARD RESET:
Use this option to reset the MGI. This option only applies to MGI
cards installed on the system. It does not apply to the on-board MGI ports.
•
PUBLIC IP:
The MGI will originate communications, to ITP/VOIP devices outside
the local network, using this IP address. The system identifies communications
to/from this address as “public”. This allows devices, on remote
networks/subnets, to establish communications with the system, without
exposing your LAN.
•
PUBLIC RTP:
This defines the UDP port range on the firewall forwarded to the
MGI resources.
•
MAC ADDR:
Read only field that displays the MAC Address of the MP10/MP10a
card.
•
IP Version
: Select either IPV4 or IPV6 IP address format.
•
NOTE: IPV6 is not supported in the US
PROGRAM KEYS
UP & DOWN
Used to scroll through options
KEYPAD
Used to enter selections
SOFT KEYS
Move cursor left and right
SPEAKER
Used to store data and advance to next MMC
ACTION
DISPLAY
1. Press TRANSFER 831.
Display shows the first trunk on selected MGI
[3801] IP ADDRESS
168.219. 76.101
card.
2. Press RIGHT soft key to move cursor.
[3801] IP ADDRESS
168.219. 76.101
Home Page
Table of Contents
