CHAPTER 2. MMC Programming
OfficServ 7200 Programming Guide
Samsung Business Communications
2-322
[837] SIP OPTIONS
This MMC permits the adjustments of optional Session Initiation Protocol (SIP) trunk pa-
rameters. The MCP supports SIP and H.323 on a per-call-per-port basis. The settings are
system wide.
When changing any IP address/value, three digits must be entered for each
(octet) field. For example, 192.168.1.10 should be entered as 192 168 001 010.
No
Parameter
Description
Default
00 GATEWAY
CALL ID
Numeric system identifier (up to 12 digits).
‘1234’
01 CALLER
ID
TYPE
This option controls the calling party identification type.
There are 3 possible selections:
0 GWID: shows the gateway call ID.
1 ANI: shows the calling station number (default)
2 IP: shows the calling H.323 gateway IP address.
ANI
05 DEFAULT
DIL
NO
This allows programming of the default direct-in-line
number when digits are missing or incorrect on an in-
bound call.
5000
06 UDP
PORT:
TRUNK
Sets the UDP port used on a SIP trunk call.
5060
07 UDP
PORT:
PHONE
Sets the UDP port used on a SIP phone call.
5070
09 RE-TRANS.
T1 TIME
The initial re-transmission time if there is no answer,
based on the RFC2543 specification. The range is
0~9900 ms.
500 ms
10 RE-TRANS.
T2 TIME
The maximum re-transmission time if there is no answer,
based on the RFC2543 specification. The range is
0~9900 ms.
4000 ms
11 RE-TRANS.
T4 TIME
The time the User Agent Server waits after receiving the
ACK message. Based on the RFC2543 specification. The
range is 0~9900 ms.
5000 ms
12 GENERAL
RING TM
The server retransmits the response for this length of
time until the requested retransmission is received. For
example, the wait time after sending 200 OK for INFO.
The range is 0~99900 ms.
5000 ms
13 INVITE
LING
TM
After the client sends ACK for the INVITE Final Response, the
client cannot confirm if the server received the ACK message.
The client waits for this length of time after sending ACK
for the Final Response. The range is 0~99900 ms.
5000 ms
