13
SECURING
SCREWS
REMOVE
KNOCKOUTS
ADDING AN
iDCS 14 BUTTON KEY STRIP
•
Place the keyset face down on a flat surface.
•
Remove the base pedestal by placing your thumbs over the attachment clips
and press outward while simultaneously pressing down on the keyset body
with your fingertips.
•
Remove the ribbon cable knockout from the bottom of the keyset.
•
Clip the 14 button strip to the side of the keyset.
•
Plug one end of the ribbon cable into the keyset and the other end into the
14 button strip.
•
Place the support bracket over the ribbon cable and secure with the six
screws provided.
•
Reattach the base pedestal.
ADDING A KEYSET
DAUGHTERBOARD MODULE
•
Place the keyset face down on a flat surface.
•
Remove the base pedestal by placing your thumbs over the attachment clips
and press outward while simultaneously pressing down on the keyset body
with your fingertips.
•
Remove the two knockouts from the bottom of the keyset.
•
Plug in the daughter module and secure with the two screws provided.
12
REMOVE KNOCKOUTS
CONNECT RIBBON CABLE
Home Page
iDCS Keyset
Table of Contents