23
CALL PROCESSING
SYSTEM HOLD
When you are connected to any call, press
HOLD
. The call will flash at the keyset. If
this call appears on a line button at other keysets, it will flash at those keysets also.
•
To take the caller off hold, press that button and the flashing LED will go
steady again. Resume the conversation—
OR
—press the
HOLD
button. The
flashing LED will go steady again and you will be connected to the call again.
Resume the conversation.
NOTE: While on a call, pressing a line button, route button or flashing
CALL
button
will automatically put your first call on hold and connect you to the new call.
Automatic Hold under Customizing Your Keyset.
EXCLUSIVE HOLD
To place an outside call on hold at your phone so that other users cannot get it:
•
Press the
HOLD
button twice. The call will flash on your keyset and this line
will show a steady indication on other keysets.
•
To retrieve the call, press the flashing line button or press the
HOLD
button a
third time.
NOTE: Intercom calls will always be placed on exclusive hold.
REMOTE HOLD
When you wish to place a call on hold at another station.
•
Press
TRANSFER
and dial the station number (or press the appropriate
DSS
button)
•
Press the
HOLD
button. This will place the call on system hold on an available
CALL
button or Line button at the remote station and return you to dial tone.
NOTES:
1.
If the destination station does not have any free
CALL
buttons or line buttons
you will hear No More Calls tone and must return to the other party by press-
ing the
TRANSFER
button (or the
RETURN
soft key in the display).
2.
Intercom calls cannot be put on remote hold.
22
2.
If the Hot Keypad feature has been turned off, you must first lift the handset
or press the
SPEAKER
button before dialing.
AUTO CAMP-ON
When you want to automatically camp on to a busy station without pressing the
camp on button every time you call a busy station, you can set your phone for auto
camp-on.
•
With the handset on-hook, press
TRANSFER
and then dial
110
.
•
Dial
081
to turn
ON
auto camp-on or
080
to turn it
OFF
.
•
Press
TRANSFER
to store your selection.
From the LCD:
•
Press the
MENU
button.
•
Scroll to
CONFIG
option and press
ENTER
.
•
Scroll to
STATION ON/OFF
and press
ENTER
—
OR
—you may dial
0
and
immediately enter the option.
•
Scroll to
AUTO CAMPON
option. Press
ENTER
to change status.
•
Press
CANCEL
to return to main configuration screen—
OR
—press
END
to
return to idle screen.
CALLING YOUR SYSTEM OPERATOR
•
Dial
0
and press
SEND
button to call your system operator or group of opera-
tors.
•
If you want to call a specific operator, dial that person’s extension number.
NOTE: If the Hot keypad feature has been turned off, you must first lift the handset
or press the
SPEAKER
button before you begin dialing.
Home Page
ITP-5012L
Table of Contents
