BUSY STATION CALLBACK
When you call another station and receive a busy signal:
•
Press the
CBK
button, if programmed, or dial
44
.
•
When the busy station becomes free, your keyset will ring.
•
Lift the handset or press
SEND
to call the now idle station.
NOTES:
1.
A callback will be canceled if not answered within 30 seconds. If you have set
a callback, your
CBK
button will light.
2.
If the Hot Keypad feature has been turned off, you must first lift the handset
or press the
SPEAKER
button before dialing.
BUSY STATION CAMP-ON
When you call another station and receive a busy signal but you do not want to
wait for a callback:
MANUAL CAMP-ON
•
Press the
CAMP
button or dial
45
.
•
The called station will receive off-hook ring tone repeated every few seconds
and its first available
CALL
button will flash green to indicate your call is wait-
ing.
•
Wait for the called party to answer.
•
The called station must release its first call or place it on hold before answer-
ing your camp-on.
NOTES:
1.
If you receive No More Calls tone, that station has no available button to
accept your call. Hang up or leave a message.
2.
If the Hot Keypad feature has been turned off, you must first lift the handset
or press the
SPEAKER
button before dialing.
AUTO CAMP-ON
When you want to automatically camp on to a busy station without pressing the
camp on button every time you call a busy station, you can set your phone for
auto camp-on.
•
With the handset on-hook, press
TRANSFER
and then dial
110
.
•
Dial
081
to turn on auto camp-on or
080
to turn it off.
•
Press
TRANSFER
to store your selection.
19
18
INTERCOM CALLS
CALLING OTHER STATIONS
•
Dial the extension number or group number.
•
Wait for the party to answer. If you hear a brief tone burst instead of ringback
tone, the station you called is set for Voice Announce or Auto Answer. Begin
speaking immediately after the tone.
•
Finish the call by replacing the handset or press the
END
button.
NOTES:
1.
If you have a
DSS
button assigned to an extension or station group, you may
press this button instead of dialing the number.
2.
If the Hot Keypad feature has been turned off, you must first lift the handset
or press the
SPEAKER
button before you begin dialing.
ANSWERING INTERCOM CALLS
•
When your keyset rings, simply lift the handset—
OR
—press the
SEND
button
to be connected to the calling station.
•
To finish the call, replace the handset or press the
END
button.
VOICE ANNOUNCE MODE
When another station calls you, your keyset will sound a brief attention tone and
you will hear the caller’s announcement.
•
Press
SEND
to turn on the microphone and speak handsfree—
OR
— lift the
handset to reply.
•
To finish the call, replace the handset or press the
END
button.
NOTE: In order for C.O. calls to be answered handsfree, AUTO ANS CO must be set
ON.
AUTO ANSWER MODE
When another station calls you, your keyset will sound a brief attention tone and
then automatically answer the call.
•
Your microphone and speaker are turned on and you can speak handsfree. For
privacy, use the handset.
•
To finish the call, replace the handset or press the
END
button.
NOTE: In order for C.O. calls to be answered handsfree, AUTO ANS CO must be set
ON.
Home Page
ITP-5021D
Table of Contents
