15
OUTSIDE CALLS
MAKING AN OUTSIDE CALL
•
Lift the handset and press an idle outside line button, line group button or dial
a line access code to receive dial tone—
OR
—press an idle outside line button,
line group button or dial a line access code to receive dial tone through the
speaker—
OR
—press
SPEAKER
, receive intercom dial tone and dial a line
access code.
•
Dial the telephone number.
•
Finish the call by replacing the handset.
NOTE: You will receive No More Calls tone when you attempt to make a call and
there is no button available for that line.
•
If Least Cost Routing is enabled on your phone system, this button may be
labeled
LCR
or accessed by dialing an access code (usually
9
).
•
If your system is programmed to require an authorization code before making
a call, dial
plus a valid code before selecting a C.O. line.
•
If your system is programmed to require an account code before making a
call, press the
ACC
button or dial
47
plus a valid bin number, press the
ACC
, and then select a C.O. line.
See Account Codes for more infor-
For more information on authorization and account codes, see your system
administrator.
NOTE: If the Hot Keypad feature has been turned off, you must first lift the handset
or press the
SPEAKER
button before dialing.
ANSWERING AN OUTSIDE CALL
•
Lift the handset and you are automatically connected to the ringing call.
Ring Preference under Customizing Your Keyset
OR
—press the
FLASHING
CALL
button to automatically answer on the speakerphone.
NOTE: If a call is flashing at your keyset but not ringing, you must press the flash-
ing button to answer.
UNIVERSAL ANSWER
Outside lines may be programmed to ring a general alerting device. To answer
calls ringing this device, dial
67
or press the
UA
button. This device can operate in
any one of the six different ring plans.
NOTE: If the Hot Keypad feature has been turned off, you must first lift the handset
or press the
SPEAKER
button before dialing.
You must input the ID assigned to your ITP phone. See your phone system admin-
istrator to get this value. Press the
SPEAKER
button to save and exit. Select the [3.
SERVER PASS] item.
You must input the password associated with your ID. See your phone system
administrator to get this value. Press
HOLD
to backspace. Press the
SPEAKER
but-
ton to save and exit.
Completion of Settings
From the main menu, select the seventh item [
7. REBOOT
] to save all modified
settings and reboot the ITP-5107S phone.
14
INPUT SYSTEM PASSWORD
Home Page
ITP-5107S
Table of Contents
