4. Press
TRSF
to store and exit
programming OR press
SPK
to store
and advance to the next program
NOTE: Directory information is always 11 characters.
DEFAULT DATA: NONE
Names are written using the keypad. Each press of a key will select a character.
Pressing the dial pad key moves the cursor to the next position. For example, if the
directory name is “SAM SMITH,” press the number “7” three times to get the letter
“S.” Press the number “2” once to get the letter “A.” Continue selecting characters
from the table below to complete your message. Press the “A” key to change the
letter from upper case to lower case.
NOTES:
1. When the character you want appears on the same dial pad key as does the
previous character, press the
UP
key to move the cursor to the right.
2. When the system is equipped with a Samsung Voicemail system, and the
option has been enabled, changes to station names will automatically change
the voicemail box name if a voicemail box exists.
DCS KEYSETS [NOT SUPPORTED ON THE OFFICESERV 7100]
COUNT
1 2 3 4
5
DIAL 0
Q
Z
.
)
0
DIAL 1
space
?
,
!
1
DIAL 2
A
B
C
@
2
DIAL 3
D
E
F
#
3
DIAL 4
G
H
I
$
4
DIAL 5
J
K
L
%
5
DIAL 6
M
N
O
^
6
DIAL 7
P
R
S
&
7
DIAL 8
T
U
V
Q
8
DIAL 9
W
X
Y
(
9
DIAL
,
:
=
[
]
,
The
#
key can be used for the following special characters: #, space, &, !, :, ?, ., %, $, -
, /, =, [, ], @, ^, (, ), _, +, {, }, |, ;, \,“ and ~.
14
13
2. Dial the station number OR use the
[205] PASSCODE
UP
and
DOWN
keys to scroll through
PASSCODE:
,,,,
the keyset numbers and press the
right soft key to move the cursor right
3. Press
HOLD
to reset the passcode
[205] PASSCODE
PASSCODE : 1234
4. Press the right soft key to return to
step 2 OR press
TRSF
to store and exit
programming OR press
SPK
to
store and advance to the next program
DEFAULT DATA: ALL STATION PASSCODES = 1234
PROGRAM STATION NAMES
This program is used to assign a character name or identification for each exten-
sion. You may assign a name of 11 characters long.
PROGRAM KEYS
UP
&
DOWN
- Used to scroll and move cursor.
KEYPAD
- Used to enter characters.
HOLD
- Press to clear entry.
Open customer programming and follow the instructions below.
ACTION
DISPLAY
1. Press
TRSF
and then dial
104
[201] STN NAME
Display shows
2. Dial station number (e.g.,
205
)
[205] STN NAME
OR press
UP
or
DOWN
to select the
station and press the right soft key to
move the cursor
3. Enter the station name using the
[205] STN NAME
procedure described on the next page
SAM SMITH
and press the right soft key to return to
step 2
Home Page
System Admin
Table of Contents
