Samsung PC1MWFMAN, Installation Manual

3

English

3 

ĮΧʪ͝ϩ˵ʪɇ̈θ˙̷̈ϩʪθɵцΧЇϑ˵̈͝˝ϩ˵ʪߣࣄťƸƊ²ࣅϑ̈˝͝ϑࢋ

4 

ťʪθ˙ͱθ͔ӥθ̈͝˝ɵʪϩиʪʪ͝ϩ˵ʪ̈͝ʒͱͱθЇ̈͝ϩɇ͝ʒϩ˵ʪΧɇ͝ʪ̷ࡠ

• 

Ƹ͝˙ɇϑϩʪ͝ϩ˵ʪߤϑʀθʪиϑ˙θͱ͔ϩ˵ʪʪ̷ʪʀϩθ̈ʀɇ̷Χɇθϩࡡɇ͝ʒ

then remove the electrical part.

•  Connect the connectors on the panel to the connectors 

ͱ͝ϩ˵ʪ̈͝ʒͱͱθЇ̈͝ϩťA9ࡠ

– Connect the connectors of the swing motor, remote 

control sensor, and humidity sensor on the panel to 
their respective connectors on the indoor unit PCB.

–

đɇ̧ʪϑЇθʪϩ˵ɇϩϩ˵ʪʀͱ̷ͱЇθϑͱ˙ϩ˵ʪʀͱ͝͝ʪʀϩͱθϑ͔ɇϩʀ˵

each other.

•  Reassemble the electrical part.
•  Close the air filter.

²Ї͔̈ʒ̈ϩцϑʪ͝ϑͱθ

  NOTE

•  If any connector is not connected or is connected to a 

different colour connector, both the air conditioner and 
the remote control will not operate.

5 

Check whether the panel is firmly fixed to the indoor 
unit.

• 

đɇ̧ʪϑЇθʪϩ˵ɇϩϩ˵ʪϑʀθʪиϑɇθʪ˙ɇϑϩʪ͝ʪʒϩ̈˝˵ϩ̷цЇ͝ϩ̷̈

there is no gap between the ceiling and the panel, and 
that the panel is installed in parallel with the ceiling 

ɇ͝ʒϩ˵ʪʀʪ̷̈̈͝˝̟ͱ̈͝ϩϑࡠ

– If there is a gap between the ceiling and the panel, 

adjust the height of the indoor unit.

  CAUTION

•  If the panel is installed incorrectly onto the cassette, 

air may leak out.

đɇ̧ʪϑЇθʪϩ˵ɇϩϩ˵ʪθʪ̈ϑ͝ͱ˝ɇΧ˵ʪθʪࢋ

đɇ̧ʪϑЇθʪϩ˵ɇϩϩ˵ʪθʪ̈ϑ͝ͱ˝ɇΧ˵ʪθʪࢋ

Condensation and drops

Air leaks

Dust  

accumulates

Air leaks  

from ceiling

Ã͝ʀͱ͔Χ̷ʪϩʪ̈͝ϑϩɇ̷̷ɇϩ̈ͱ࣍͝˙ɇϑϩʪ̈͝͝˝࣎ΧθͱʒЇʀʪϑϩ˵ʪΧθͱɵ̷ʪ͔ϑ

as shown in the figure. Be sure to check again after the 
installation.
•  When installing the panel, if there are any gaps 

between the panel and the indoor unit due 

ϩͱ̈͝ʀͱ͔Χ̷ʪϩʪ̈͝ϑϩɇ̷̷ɇϩ̈ͱ࣍͝˙ɇϑϩʪ̈͝͝˝࣎ࡡɇ̈θɇ͝ʒ

condensation water may leak into the room. Be sure 
to remove gaps by using the indoor unit installation 

˝ɇЇ˝ʪϑ࣍ͱ͝ϩ˵ʪΧɇϩϩʪθ͝ϑ˵ʪʪϩ˙ͱθ̈͝ϑϩɇ̷̷ɇϩ̈ͱ࣎͝ࢋ

– For detailed specifications, refer to the installation 

manual for the product.