31
Temp Control &Operation Functions
- This Ice Maker function is an option.So,the following can be applied only to Model mentioned.
- Ice Maker has an automatic ice production function without extra controlling by users.
It is a kit performing a series of automatic ice producing operation that it supplies water and stores ice in the
ice bin upon the completion of ice production.
1) Initial Operation Function
1-1) When the initial power is applied,the ice tray will stand by for 2 hours.
1-2) After the 2-hour standby time,the Ice Maker Sensor will check the temperature and when it is lower than
5
℉
(-15
℃
)for more than 5 minutes,it will separate the ice from the ice tray into the ice bin by rotating and
twisting the ice tray.At this time,it carries out the ice separation whether there is ice in the ice tray or not.
2) Water Supply Function
2-1) Upon the completion of ice separating operation (initial ice separating operation, normal ice separating
operation,ice separating operation by Test funct i on) and t he horizontal leveling of the ice tray, when it is
evaluated that the ice tray is horizontally leveled, water will be supplied to the ice tray by turning on the
Water Solenoid in the machine compartment. (When it is detected as no water supply with low water
pressure taken into consideration, it will perform water supply operation up to 4 times.)
2-2) Water Supply Operation
- The Water Supply Valve opens after the completion of normal ice ejection, water is supplied for the
previously set option time (Factory set value:5.0 sec)and the Water Supply Valve is shut off.
- Water is to be supplied regardless of F/R-Door Open.
- The Ice Test S/W does not operate during water supply.
- After the water supply is completed, it will evaluate Water Supply or No Water Supply one and a half
minutes later.
- When it becomes water supply condition due to no water supply, water supply time will be 1.5 sec,1 sec
and 2 sec.
- When it is judged to do water supply after the 4-time water supply attempts, water supply operation will
stop. In this case,the ice eject will standby for 58 minutes.
- To prevent additional water supply due to the remaining ice in the ice tray slot with the ice maker sensor
on the bottom of it,it will stop water supply operation when there are no water supply signals keep on
after the water supply attempts for the number of previous water supply.For the first time water supply
after the power on,it will perform water supply once and if it is sensed as no water supply,it will stop water
supply operation.If the number of previous water supply is 3 times,it will try to supply water for 3 times.
And, if it is sensed as no water supply,it will stop water supply operation, In this case, the ice eject
standby time is 70~110 minutes.
- When it is sensed as no water supply continuously, it wi l l carry out water supply operation for the
number of previous water 1 times.
10-8) Ice Maker Function (Only applicable to Model with the Auto Ice Maker function)
TRAY-ICE
SCREW
SUPT-RUBBER
EJECT-SENSOR
EJECT-MOTOR
KNOB-TOUCH
LEVELING-SWITCH
TEST-SWITCH
GUIDE-ICE(Lever to check ice full)
COVER-SENSOR
FIXER-SENSOR
ICE-WAKER, KIT
ICE
Full-SWITCH
