8 English
Operating Guide for Samsung Double-Door Refrigerator
Things to get ready before use
Having gone through the following steps, the refrigerator is fully ready to use. If not, check power supply and
power source. Please contact local Samsung Service Center in case of any doubts or questions.
1. Install the shelves and containers dismantled for transportation to their correct positions.
2. Clear the fridge, freezer and accessories. Clean up the dust built up during packing and
shipping.
3. When the refrigerator is connected to a power source, each opening of the fridge door will turn
on the light inside the fridge.
4. Set temperature control to the lowest level and wait for an hour until the fridge is slightly chilled.
The compressor will run smoothly at the moment and produce gentle hum.
5. When internal temperature of the fridge is low enough, you can store food inside the fridge. But
remember that it takes hours for temperature to reach a suitable level after the refrigerator is
started.
NOTE
Check the range of voltage before connecting the fridge to power source. The cable and socket must be
able to stand for current above 10A.
Control panel
Fridge temp display
Power Cool & Power
Freeze
state display
Control Lock
state display
Fridge temp key
Power Cool & Power
Freeze key
Control Lock key
1.Fridge temp key
ꞏ
Press the “fridge” temp key to set temperature for the fridge.
ꞏ
Temperature of the fridge is set as the following: 5ºC→ 4ºC→ 3ºC→ 1ºC→ 7ºC→ 5ºC.
2.Power Cool & Power Freeze key
ꞏ
If the fridge is not in Power Cool & Power Freeze state, press the “Power Cool & Power Freeze” key. The
Power Cool & Power Freeze indicator light is on and the fridge enters Power Cool & Power Freeze state.
ꞏ
The compressor starts and keeps running after “Power Cool & Power Freeze” mode is enabled.
ꞏ
There are two ways to disable Power Cool & Power Freeze state:
-
Press the “Power Cool & Power Freeze” key to exit Power Cool & Power Freeze state;
-
When the fridge reaches zero Celsius degree, the fridge automatically exits Power Cool & Power Freeze
state. The “Power Cool & Power Freeze” indicator light goes off after the fridge exits the Power Cool &
Power Freeze state.
3.Control Lock key
ꞏ
Keep pressing the “Control Lock” key for 3 seconds and the Control Lock indicator light on the display is
on. Other keys except the Control Lock key are disabled.
ꞏ
Keep pressing again the “Control Lock” key for 3 seconds under locked state, the Control Lock indicator
light on the display goes off. All other keys are now enabled.
★
Adjustment after initial power-on
