14_
operating
Touch the
5. “Alarm/hold
3 sec for Filter Reset”
button (
(Filter Reset)
(Filter Reset)
) for about
3 seconds to reset the
water fi lter. The color of the
indicator (
) changes from red to off.
If you turned off the water supply, turn it back
6.
on.
For a replacement water fi lter, you can
visit your local home Improvement center
or contact the Samsung Parts distributor.
Be sure the replacement water fi lter has
the SAMSUNG logo on the box and
on the water fi lter. Link : http://www.
samsungparts.com
Removing any residual matter inside
the water supply line after installing
the water fi lter.
Turn ON the main water
1.
supply and supply water
from water supply line.
Run water through the
2.
dispenser until the water
runs clear (approx. 6 to 7
minutes). This will clean
the water supply system and remove air from
the lines.
Additional fl ushing may be required in some
3.
households.
Open the Refrigerator door and make sure
4.
there are no water leaks coming from the
water fi lter.
Be sure to fl ush the dispenser thoroughly,
otherwise water may drip from the
dispenser.
This means that there is still air in the line.
Reverse Osmosis Water Supply
IMPORTANT:
The pressure of the water supply coming out of a
reverse osmosis system going to the water inlet
valve of the refrigerator needs to be between 35
and 120 psi (241 and 827 kPa).
If a reverse osmosis water fi ltration system is
connected to your cold water supply, the water
pressure to the reverse osmosis system needs to
be a minimum of 40 to 60 psi (276 to 414 kPa.) If
the water pressure to the reverse osmosis system
is less than 40 to 60 psi (276 to 414 kPa):
Check to see whether the sediment fi lter in the
•
reverse osmosis system is blocked. Replace
the fi lter if necessary.
Allow the storage tank on the reverse osmosis
•
system to refi ll after heavy usage.
If your refrigerator has a water fi lter, it may
•
further reduce the water pressure when used
in conjunction with a reverse osmosis system.
Remove the water fi lter.
If you have questions about your water pressure,
call a licensed, qualifi ed plumber.
CONTROLLING THE
TEMPERATURE
Basic temperature of Freezer and
Refrigerator Compartments
The basic temperature and recommended
temperatures of the Freezer and Refrigerator
Compartments are 0°F and 37°F (or -18°C and
3°C) respectively. If the temperature of the Freezer
and Refrigerator Compartments are too high or
low, adjust the temperature manually.
Controlling the Freezer
temperature
The Freezer temperature can be set between -8°F
and 5°F (or between -23°C and -15°C) to suit
your particular needs. Press the Freezer button
repeatedly until the desired temperature is shown
in the temperature display. The temperature will
change by 1°F (or 1°C) with each press. See
below.
Fahrenheit : 0°F
➞
-1°F
➞
-2°F
➞
-3°F
➞
-4°F
➞
-5°F
➞
-6°F
➞
-7°F
➞
-8°F
➞
5°F
➞
4°F
➞
3°F
➞
2°F
➞
1°F
➞
0°F.
Centigrade : -18°C
➞
-19°C
➞
-20°C
➞
-21°C
➞
-22°C
➞
-23°C
➞
-15°C
➞
-16°C
➞
-17°C
➞
-18°C.
Keep in mind that foods like ice cream may melt
at 4°F (or -15.5°C). The temperature display will
Recommend Temp (Freezer) : 0°F (or -18°C )
Recommend Temp (Freezer) : 0°F (or -18°C )
DA68-02603A.indb 14
DA68-02603A.indb 14
2012.5.30 1:27:5 PM
2012.5.30 1:27:5 PM
Summary of Contents for RF323TEDBSR
Page 27: ...Memo DA68 02603A indb 27 DA68 02603A indb 27 2012 5 30 1 27 44 PM 2012 5 30 1 27 44 PM...
Page 55: ...Nota DA68 02603A indb 27 DA68 02603A indb 27 2012 5 30 1 30 25 PM 2012 5 30 1 30 25 PM...
Page 82: ...Notes DA68 02603A indb 26 DA68 02603A indb 26 2012 5 30 1 33 8 PM 2012 5 30 1 33 8 PM...
Page 83: ...Notes DA68 02603A indb 27 DA68 02603A indb 27 2012 5 30 1 33 8 PM 2012 5 30 1 33 8 PM...
