English - 34
Using the Ice & Water Dispenser together
To get Ice and water, push the Ice lever ( 1 ) first
for ice, then move your glass down and press the
water dispenser lever ( 2 ) for water.
MAINTAINING THE ICE BUCKET
• To clean the ice bin/bucket, wash with a mild
detergent, rinse well, and dry thoroughly.
Do not use harsh or abrasive cleaners or
solvents.
• Ice is made in cubes.
When you select “Crushed”, the ice maker
grinds the ice cubes into crushed ice.
• When you select Cubed Ice after using the
Crushed Ice mode, a small amount of residual
crushed ice might be produced.
• The ice cubes generated by the rapid ice
making process will look white, which indicates
they are generated normally.
• If ice doesn’t come out, pull out the ice bucket
and press the Test button located on the right
side of ice maker.
See the illustration under Making Ice below.
• Do not press the Test button continuously if the
tray is filled with ice or water.
Water may overflow or ice may jam the bucket.
MAKING ICE
• To fill the ice bucket to maximum capacity after
installation, follow these steps:
1. Allow your refrigerator to operate and cool
down for 24 hours (or 1 full day).
- Waiting 24 hours will allow your ice maker to
cool properly.
2. Dispense 4 to 6 ice cubes into a glass.
3. After another 8, and then 16 hours, dispense a
full glass of ice.
• To test the ice maker, press the Test button on
the ice maker.
You will hear the refrigerator chime (ding-dong).
When the chime sounds, release the Test
button.
• The chime sounds automatically again to let you
know the ice maker is working well.
Check the water
level
Test button
• If you want to remove the ice cubes
without using the ice bucket, please turn
the ice maker off.
(However, remove the front cover from
the ice maker.)
The ice cubes in the ice maker can spill
out over the drawer.
• Do not put food in the ice bucket.
If you store food in the ice bucket, the
food may get in the way of the ice maker
while opening/closing the door, causing
damage to the ice maker.
• Note that the ice cubes in the ice bucket
may spill out over the drawer when
removing the ice bucket from the drawer.
If this is the case, be sure to clear the ice
cubes that spilled out of the drawer.
• If a power failure occurs, ice cubes
may melt then freeze together when
the power comes back on, causing the
dispenser to be out of order.
To prevent this problem, after a power failure, pull
out the ice bucket and discard the residual ice or
water.
• If you use all the ice at once, you must
repeat Steps 2 and 3 above.
However, only wait 8 hours before
dispensing the first 4 to 6 ice cubes.
This will replenish the ice cubes and
ensure maximum ice production.
CAUTION
CAUTION
CAUTION
CAUTION
DA68-03194Z-(EN+FR+AR)-01.indb 34
2018. 12. 13. 오후 5:24
