English - 23
SETTING
UP
LEVELING THE REFRIGERATOR
AND ADJUSTING HEIGHT AND
GAP OF THE DOORS
How to level the refrigerator
To avoid a hazard due to
instability of the refrigerator,
please place the refrigerator
on a horizontal support and
levelled in accordance with
the following instruction for
installation.
Failing to do so may result in
the refrigerator tipping and a
personal injury.
If the front of the appliance is
slightly higher than the rear,
the door can be opened and
closed more easily.
Setting up the refrigerator on
an uneven surface will cause
the refrigerator to be uneven.
- When install the refrigerator,
the legs should touch the
floor surely.
The legs should be located
on the back of under the
each door.
Insert it with flathead
screwdriver and tighten up to
arrow direction.
If the Refrigerator is put on a floor that is not level,
it can cause a height difference between the doors.
• Insert a Flat-Head (-) Screwdriver into the slot
in the Leveling Leg Control Lever and adjust the
level by turning the Control Lever clockwise or
counter-clockwise.
When you rotate the Lever clockwise, you raise
the refrigerator.
When you rotate the Lever counter-clockwise,
you lower the refrigerator.
Flat-blade
screwdriver(-)
Control Lever
• If the Refrigerator is not level back and
front, put a solid panel (such as a plastic
panel, a plastic ruler, etc.) on the floor
where the rear legs will rest, and then fix
it in place with plastic tape.
When you push in the Refrigerator, make
sure the rear legs rest on the panel.
• If you have a wooden floor or similar soft floor,
take care not to damage the floor when pushing
the Refrigerator into place.
DA68-03194H (EN)-06.indd 23
2016. 3. 24. �� 3:21