English - 29
O
PERA
TING
( 6 ) Ice Type
Touch the Ice Type button to change the
ice type.
Each time you touch the Ice Type button,
the cubed and crushed ice modes
alternate and the Cubed or Crushed ice
icon lights up, indicating your selection.
If you don’t need ice, turn the function off
to save on water and energy consumption.
(See Ice Maker Off below.)
Lighting
Touch the Cubed button for three seconds
to set the Dispenser LED lamp (under the
display) to continuous mode so that it
stays on continuously.
If you want the Dispenser lamp to come on
only when some one uses the dispenser,
touch this button for 3 seconds again to
turn the continuous mode off.
( 7 ) Ice Maker Off (Hold 3 sec)
Touch the Ice Maker Off button for
3 seconds until the Ice Maker Off Indicator
( ) illuminates.
( 8 ) Filter
Water filter usage
This icon will light up when you need to
change the filter.
After you use about 300 gallons of water,
the filter indicator lights up. (in about 6
months)
The icon will blink red for several seconds
when you open or close the door.
After you install the new water filter, touch
and hold the Crushed Ice button for
3 Seconds to reset the filter.
- If water is not dispensing or dispensing
slowly, you need to replace the water
filter because the water filter is clogged.
- Some areas have large amounts of lime
in their water, which causes the water
filter to clog more quickly.
Exhibition Mode
• In case of Exhibition Mode, It seems
working but doesn’t make cool air.
To cancel this mode, touch the Freezer,
Fridge and Door Alarm buttons at the
same time for 5 seconds until “Dingdong”
sounds.
Or you can cancel the exhibition mode
by turning the power off.
CAUTION
DA68-03194H (EN)-06.indd 29
2016. 3. 24. �� 3:21