12
Check the dimensions of your entrance door.
Clean your refrigerator.
Wipe the inside and outside of your
refrigerator with a dry cloth.
Store food in the refrigerator.
Wait for at least two or three hours after
plugging your appliance in and before
storing food and other articles inside.
Check the dimensions of your entrance door to determine whether the refrigerator can pass through it.
*
Dimension of the Appliance
Allow sufficient space to install the
appliance on a flat surface.
If your appliance is not level, the
internal cooling system may not
work properly.
Width
Depth
Height
Dimension
(mm)
855
756
1728
Remarks
With door
With hinge
INSTALLING REFRIGERATOR
Over 10cm
Over 10cm
Over 10cm
Remove all packing materials
：
Remove the foam pad for the appliance before using it.
Allow a clearance of 10cm to the right, left and rear side when installing the appliance; as this will
help to reduce power consumption.
5
At level 2, 4, 6 and 8, LED marked with ( ) will fully light
up after blinking for 5 seconds .
( )
。
TEMPERATURE CONTROL
TEMPERATURE CONTROL
（
RS20NR**
）
Cold
Normal
Colder
LED
CONDITION
Level
1
2
3
4
5
6
7
8
9
Reference
(
On
)
(
Off
)
(
Blink
)
NOTE
•
※
FRE. TEMP BUTTON
To set the freeze temperature, push
the button repeatedly to select from
level 1 (cold) to level 9 (colder).
The higher level you set, the lower temperature inside the unit.
REF. TEMP BUTTON
To set the refrigerator temperature, push
the button repeatedly to select from level
1 (cold) to level 9 (colder).
Control Level Table
⑤
④
③
②
①
FREEZE
Refrigerator
The freeze temperature can be set to any level from
level 1 (cold) to level 9 (colder).
The refrigerator temperature can be set to any level
from level 1 (cold) to level 9 (colder).
- At each level, the LED indicators turn on or off as
shown on the table.
Press REF. TEMP button repeatedly until the
desired level is reached.
- At each level, the LED indicators turn on or off as
shown on the table.
Press FRE. TEMP button repeatedly until the
desired level is reached.
For your convenience, your refrigerator temperature control has been preset in the factory.
Refrigerator temperature controller shall be set as “NORMAL” (level 5: -20
℃
for Freeze
and 3
℃
for Fridge if your refrigerator is installed first time or has been switched off for a long time.
When accidental power off happens and the power is reconnected, please check the status of
temperature controller. User is suggested to set according to your actual application conditions
and normal recommended setting is NORMAL.
FRE. TEMP
REF. TEMP
colder
NOTE
cold
LED No.
LED No.
LED No.
LED No.
LED No.
O
PE
RA
TI
NG
IN
ST
RU
CT
IO
NS
