English 35
Se
tting up
Completing the set up
Now that you have your new refrigerator installed in place, you are ready to set up and
enjoy the features and functions of the appliance.
By completing the following steps, your refrigerator should be fully operational.
1.
Make sure your refrigerator is in an appropriate location with reasonable clearance
between it and the wall. Refer to installation instructions in this manual.
2.
Once the refrigerator is plugged in, make sure the interior light comes on when you
open the doors.
3.
Set the Temperature control to the coldest temperature and wait for an hour.
The freezer will get slightly chilled and the motor will run smoothly.
Reset the refrigerator and freezer to the temperatures you want.
4.
After you plug the refrigerator in, it will take a few hours to reach the appropriate
temperature.
You can store food and drinks in the refrigerator after the temperature is sufficiently
cool.
NOTE
•
If condensation or water drops appear on both sides of the fridge door’s central part,
turn the Energy Saver mode off after removing the condensation.
(See the explanation of the Energy Saver button in “Using the control panel” on page 38.)
Preventing Power Cord Damage
To prevent power cord damage, fix any
excess power cord to the top rear of the
refrigerator as shown in the illustration
below.
DA68-02981N-00.indb 35
DA68-02981N-00.indb 35
2015. 3. 3.
9:34
2015. 3. 3.
9:34
Summary of Contents for RS25J500D
Page 119: ...Espa ol 59 Notas DA68 02981N 00 indb 59 DA68 02981N 00 indb 59 2015 3 3 9 34 2015 3 3 9 34...
Page 178: ...58 Fran ais Notes DA68 02981N 00 indb 58 DA68 02981N 00 indb 58 2015 3 3 9 34 2015 3 3 9 34...
Page 179: ...Fran ais 59 DA68 02981N 00 indb 59 DA68 02981N 00 indb 59 2015 3 3 9 34 2015 3 3 9 34...
