48
The freezer light is located in the bottom of the
auger motor case. The light is covered by an
opaque cover.
1. Remove the screw and the light cover.
1. Pull out the screw caps and remove screws (6).
2. Remove the ductwork of the evaporator fan in the
direction of the arrow as shown.
3. Disconnect the wire connector.
1. Remove the screw cap and screw.
2. Slide the upper fan ductwork out while
disconnecting the wire connector (Lamp and
Thermistor).
The evaporator fan is located in the lower rear of
refrigerator. This fan circulates cold air in the
refrigerator.
1. Remove screw(4) located at the four corners of
the fan bracket.
2. Take the fan motor assembly off.
Upper Ductwork
Freezer Light
Evaporator Cover in Freezer
5. DISASSEMBLY AND REASSEMBLY
Evaporator Fan Motor
Summary of Contents for RS265 LAWP
