1. Disconnect the power cord of the refrigerator.
2. Remove the fixed screws (6) of compressor
cover.
3. Slide up and take off the compressor cover to
see the machine compartment.
4. Press the tab in electric box cover to take out
by using a driver.
When the solenoids receive a signal from the micro-
processor, they supply water to the water dispenser
or the ice maker.
1. Remove bracket screw (1) from electric box.
2. Take the solenoids assembly out.
3. Disconnect water tubes (3).
The condenser Fan is located in the middle of
machine compartment. It cools down the sub-
condenser and the compressor.
1. Disconnect the condenser fan wire.
2. Remove screw (1) from the drain water tray.
3. Take the condenser fan assembly off.
The sub-condenser is located in the machine
compartment. The heat is extracted by
condenser fan.
1. Desolder the compressor discharge
&
the sub-condenser outlet.
2. Take out the sub-condenser.
50
Machine Compartment
&
&
Electric Box
5. DISASSEMBLY AND REASSEMBLY
5-4) Machine Compartment Disassembly
(+)
driver
PCB-MAIN ASSY
Water Solenoids
Condenser Fan
Sub-condenser
Desoldering Point
Summary of Contents for RS265 LAWP
