18_Operating
Controlling the Fridge temperature
SETTING UP YOUR SIDE-BY-SIDE REFRIGERATOR
The fridge temperature can be set between 7ºC and 1ºC to suit your particular
needs. Press the Fridge button repeatedly until the desired temperature is
shown in the temperature display. The temperature control process for the
Fridge works just like the Freezer process. Press the Fridge button to set your
desired temperature. After a few seconds, the Fridge will begin tracking towards
the newly set temperature. This will be reflected on the digital display.
Note: The temperature of the freezer or the fridge may rise when opening the
doors too frequently, or if a large amount of warm or hot food is placed
in either side. This may cause the digital display to blink. Once the freezer
and fridge return to their normal set temperatures, the blinking will stop.
If the blinking continues, you may need to “reset” the refrigerator. Try
unplugging the appliance, wait about 10 minutes and then plug in again.
If you can’t solve the problem by this method, please contact SAMSUNG
maintenance personnel.
USING THE ICE TRAY (OPTION)
1. Use the ice tray when the freezer is below 0ºC.
2. Take out the ice tray, pour drinking water (at room temperature)
into it and check the water level. Do not pour too much water to
avoid spilling.
3. Place the ice tray to its original position.
4. After certain time, the water in the ice tray will freeze. Take out the
ice tray if needed.
5. Rotate the two ends of the ice tray in the reverse direction as shown in the
figure, ice will fall into a container for food.
Note:
•
The ice tray can be used when the freezer is below 0ºC.
•
For optimal ice-making effect, press the “Power Freeze” button before
making ice. After stable operating, put the ice tray filled with a certain
amount of water into the refrigerator.
•
While making ice, you’d better put the ice tray on the first layer shelf
edge of the freezer, so as to speed up ice making.
•
Actual ice tray type may differ from photo, please in kind prevail.
•
While making ice, you’d better put the ice tray filled with water
separately on the first layer shelf, so as to save time of ice making.
