setting up
_1
Remove any residual matter inside the
filt
er. (Model with the
filt
er)
- Open the main water tap to check whether
water is running through the water tube on
the water inlet side of the
filt
er.
- If water does not come out through the line,
check whether the tap is open.
- Leave the tap open until clean water is
running out and any residual matter that built
up during manufacturing has been removed.
Attach the
filter
lock stations.
- Hold the
filt
er lock stations in the appropriate
position (under the sink for example) and fix it tightly
into place where to screw.
Secure the
filt
er in position.
- Fix the
filt
er in position, as shown in the
figure on the right.
setting up your side-by-side
refrigerator
01
s
E
tting
u
P
select the location where the
filt
er is to
install. (Model with the
filt
er)
- If you wish to reassemble the water inlet and out-
let sides of the
filt
er during
filter
installation,
see the reference illustration.
- Cut the water line attached to the
filte
r to the
appropriate place after measuring the distance
between the
filt
er and the cold water tap.
COUPLER
SIDE OF
FILTER
WATER INLET
SIDE OF
FILTER
LINE OUTLET
90 degree
FILTER
WATER
REFERENCE
WATER LINE
FILTER
WATER
OUTLET SIDE
OF
FILTER
TWO
FILTER
LOCK
STATION
TWO
FILTER
LOCK
STATION
TIGHTENING
BAND
FILTER
WATER TUBE
FILTER
LOCK
STATIONS
