setting up
_21
setting up your side-by-side
refrigerator
Removing any residual matter inside the water supply line after
installing filter.
1.
Turn ON the main water supply & turn OFF the valve
to the water supply line.
2.
Run water through the dispenser until the water runs
clear (approx. 1L). This will clean the water supply
system and remove air from the lines.
3.
Additional flushing may be required in some
households.
4.
Open the refrigerator door and make sure there are
no water leaks coming from the water filter.
A newly installed water filter cartridge may cause
water to briefly spurt from the water dispenser. This
is due to air getting into the line. It should pose no
problem to operation.
Check the amount of water supplied to the ice tray. (Optional)
1.
Lift up the icemaker bucket and gently pull out of the freezer.
2.
When you press the Test button for 1.5 seconds, the ice cube container is filled with water
from the water supply tap after ice tray is twisted. Check to make sure the amount of water is
correct(see the illustration below).
If the water level is too low, the ice cubes will be small. This is a water pressure problem from
with in the main water pipes, not the refrigerator.
10
S
E
G
NI
T
T
U
P
Ice maker
1
Ice
Water
2
Check the water level
Test button
Feeler Arm
