SEVERE WARNING SIGNS FOR INSTALLATION
•
Do not install the refrigerator in a damp place or place where it may come in contact with water.
- Deteriorated insulation of electrical parts may cause an electric shock or fire.
•
Do not place this refrigerator in direct sunlight or expose to the heat from stoves, room heaters or other appliance.
•
Do not plug several appliances into the same multiple power board.
The refrigerator should always be plugged into its own individual electrical which has a voltage rating that matched
the rating plate.
- This provides the best performance and also prevents overloading house wiring circuits, which could cause a fire
hazard from overheated wires.
•
If the wall socket is loose, do not insert the power plug.
- There is a risk of electric shock of fire.
•
Do not use a cord that shows cracks or abrasion damage along its length or at either end.
•
Do not bend the power cord excessively or place heavy articles on it.
•
Never unplug your refrigerator by pulling on the power cord. Always grip plug firmly and pull straight out from the
outlet.
- Damage to the cord may cause short-circuit, fire and/or electric shock.
•
Do not use aerosols near the refrigerator.
- Aerosols used near the refrigerator may cause an explosion or fire.
•
This refrigerator must be properly installed and located in accordance with the manual before it is used.
•
After unpacking, keep the packing materials out of reach of children.
- There is a risk of death from suffocation if children put them over their head.
•
Connect the power plug in proper position with the cord hanging down.
- If you connect the power plug upside down, wire can get cut off and cause fire or electric shock.
•
Make sure that the power plug is not squashed or damaged by the back of the refrigerator.
•
When moving the refrigerator, be careful not to roll over or damage the power cord.
- This constitutes a fire hazard.
•
The appliance must be positioned so that the plug is accessible after installation.
SEVERE WARNING SIGNS FOR TRANSPORTATION AND SITE
•
When transporting and installing the appliance, care should be taken to ensure that no parts of the refrigerating
circuit are damaged.
- Refrigerant leaking from the pipe work could ignite or cause an eye injury. If a leak is detected, avoid any naked
flames or potential sources of ignition and air the room in which the appliance is standing for several minutes.
•
In order to avoid the creation of a flammable gas-air mixture if a leak in the refrigerating circuit occurs, the size of the
room in which the appliance may be sited depends on the amount of refrigerant used.
•
Never start up an appliance showing any signs of damage. If in doubt, consult your dealer. The room where the
refrigerator will be sited must be 1m³ in size for every 8g of R600a refrigerant inside the appliance. The amount of
refrigerant in your particular appliance is shown on the identification plate inside the appliance.
WARNING
WARNING
