SEVERE WARNING SIGNS FOR INSTALLATION
•
Do not install the refrigerator in a damp place or place where it may come in contact with water.
- Deteriorated insulation of electrical parts may cause an electric shock or fire.
•
Do not place this refrigerator in direct sunlight or expose to the heat from stoves, room heaters or other appliance.
•
Do not plug several appliances into the same multiple power board. The refrigerator should always be plugged into
its own individual electrical which has a voltage rating that matched the rating plate.
•
Do not plug several appliances into the same power socket. The refrigerator should always be plugged into its own
individual electrical which has a voltage rating that matched the rating plate.
- This provides the best performance and also prevents overloading house wiring circuits, which could cause a fire
hazard from overheated wires.
•
If the wall socket is loose, do not insert the power plug.
- There is a risk of electric shock of fire.
•
Do not use a cord that shows cracks or abrasion damage along its length or at either end.
•
Do not bend the power cord excessively or place heavy articles on it.
•
Never unplug your refrigerator by pulling on the power cord. Always grip plug firmly and pull straight out from the
outlet.
- Damage to the cord may cause short-circuit, fire and/or electric shock.
•
Do not use aerosols near the refrigerator.
- Aerosols used near the refrigerator may cause an explosion or fire.
•
This refrigerator must be properly installed and located in accordance with the manual before it is used.
•
After unpacking, keep the packing materials out of reach of children.
- There is a risk of death from suffocation if children put them over their head.
•
Connect the power plug in proper position with the cord hanging down.
- If you connect the power plug upside down, wire can get cut off and cause fire or electric shock.
•
Make sure that the power plug is not squashed or damaged by the back of the refrigerator.
•
When moving the refrigerator, be careful not to roll over or damage the power cord.
- This constitutes a fire hazard.
•
The appliance must be positioned so that the plug is accessible after installation.
SEVERE WARNING SIGNS FOR TRANSPORTATION AND SITE
•
When transporting and installing the appliance, care should be taken to ensure that no parts of the refrigerating
circuit are damaged.
- Refrigerant leaking from the pipe work could ignite or cause an eye injury. If a leak is detected, avoid any naked
flames or potential sources of ignition and air the room in which the appliance is standing for several minutes.
•
In order to avoid the creation of a flammable gas-air mixture if a leak in the refrigerating circuit occurs, the size of the
room in which the appliance may be sited depends on the amount of refrigerant used.
•
Never start up an appliance showing any signs of damage. If in doubt, consult your dealer. The room where the
refrigerator will be sited must be 1m³ in size for every 8g of R600a refrigerant inside the appliance. The amount of
refrigerant in your particular appliance is shown on the identification plate inside the appliance.
WARNING
WARNING
QS Guide (HM10')-A과제(EN).indd 3
2010.3.9 8:5:20 PM
