Samsung RSH5SBBP, User Manual

12_

setting up

chEcKING ThE WATER 
dISpENSER lINE (OpTIONAl)

A water dispenser is just one of the helpful features 
on your new Samsung refrigerator. To help promote 
better health, the Samsung water filter removes 
unwanted particles from your water. However, it 
does not sterilize or destroy microorganisms. You 
will need to purchase a water purifying system to do 
that. In order for the icemaker to operate properly, 
water pressure of 138 ~862 Kpa is required. Under 
normal conditions, a 170 cc paper cup can be filled 
in 10 seconds. If the refrigerator is installed in an area 
with low water pressure (below 138 Kpa), you can 
install a booster pump to compensate for the low 
pressure. Make sure the water storage tank inside 
the refrigerator is properly filled. To do this, press the 
water dispenser lever until the water runs from the 
water outlet.  

Water Line installation Kits are included. You can 
find it in one of the freezer drawers.

INSTAllING ThE WATER 

dISpENSER lINE

For Interior model

Parts for water line Installation

Connecting to the water supply line

1. first, shut off the main water supply line.
2. locate the nearest cold, drinking water line.
3. follow the Water line Installation Instructions in the 
    installation kit.

4.  After connecting the water supply to the water 

filter, turn your main water supply back on and 
dispense about 1l to clear and prime the water 
filter.

Connecting the water line to the 

refrigerator

1.  Remove the dust cap from the water line on the 

rear of the unit and fit a compression nut from the 
install kit.

2.  Remove the water pipe from the install kit and fit a 

compression nut to one end.

3.  Join the two pipes together using the compression 

joint from the install kit ensuring that the joint is 
water tight.

4.  Join the other end of the install pipe to the main 

water supply and turn on the water to check for 
leaks.

Only connect the water line to a drinkable water 
source.
If you have to repair or disassemble the water 
line, cut off 6.5mm of the plastic tubing to
make sure you get a snug, leak-free connection.  

Before being used, the leakage in these 

places should be examined

CAUTION

The water line must be connected

to the cold water pipe. If it is connected 

to the hot water pipe, it may cause the

purifier to malfunction.

1

  Water line fixer and screws

2

Pipe connector

3

  Water line

4

  Water Filter

Close Main

Water pipe

Close Main

Water pipe

NO GAP

Remove 

cap

Water Line

from unit

Water Line

from Kit

No gap

Loosen a

CAUTION

DA99-02318A(0.5).indd   12

2011.5.31   5:2:1 PM

DA99-02318A(0.5).indd   12

2011.5.31   5:12:31 PM