Samsung RSH7 series, User Manual

setting up

_21

01 SETTING UP

select the location where the purifier is to 

install. (Model with the purifier)

-    If you wish to reassemble the water inlet and outlet 

sides of the purifier during purifier installation, see 
the reference illustration.

-    Cut the water line attached to the purifier to the 

appropriate place after measuring the distance 
between the purifier and the cold water tap.

Replacement Instructions

1. Shut off water supply.
2. Note the Flow direction on the filter.
3.  Insert water supply tube into the inlet side of the 

filter until the tube stop.

4.  After inserting tube, put together the clip strongly.   

The Clip fix the tube.

5.  Turn on the water and check for leaks. If leaks 

occur, repeat step 1,2,3,4. If leaks persist, 
discontinue use and call your supporting dealer.

6. Flush filter for 5 minutes before use.

Remove any residual matter inside the 

purifier. (Model with the purifier)

-   Open the main water tap to check whether water 

is running through the water tube on the water inlet 
side of the purifier.

-   If water does not come out through the line, check 

whether the tap is open.

-   Leave the tap open until clean water is running 

out and any residual matter that built up during 
manufacturing has been removed.

Attach the purifier lock-clip.

-   Hold the purifier lock-clip in the appropriate position 

(under the sink for example) and fix it tightly into 
place where to screw.

Secure the purifier in position.

-   Fix the purifier in position, as shown in the figure on 

the right.

WARRANTY INFORMATION

This water line installation is not covered by the 
refrigerator or ice maker manufacturer’s warranty.
Follow these instructions carefully to minimise the risk of 
expensive water damage.

Note:

If the coupler does not fit on the current tap, go
the nearest authorised service dealer and purchase the 
right couplers fittings.

COUPLER “A”

TAP

COUPLER

SIDE OF

PURIFIER

WATER INLET

SIDE OF PURIFIER

LINE OUTLET

90 degree

PURIFIER WATER

CAUTION

Locking Clip

Insert Locking Clip After 

tube seated

WATER SUPPLY

INLET SIDE

PERMEAT

FLOW DIRECTION

Note :

You must also ensure 

that the cut is square 

and not at any sort 

of angle as this could 

cause a leak

WATER LINE

PURIFIER

WATER

OUTLET SIDE

OF PURIFIER

PURIFIER LOCK-CLIP

WATER TUBE

PURIFIER LOCK-CLIP

PURIFIER