Installation
English
30
Ins
tallation
CAUTION
Before moving the refrigerator, make sure
to turn the levelling feet counter clockwise
so that the bottom of the refrigerator at
least 66 mm from the floor.
STEP 5
Attach the door support (glass door models only)
A
To prevent the refrigerator from falling or
shaking while it is operating or when the
door guard is fully loaded but the fridge is
empty, follow these instructions to attach
the
door support (A)
. This work must be
done by two persons.
1.
Tilt the refrigerator backward, and have
one person hold the refrigerator from
the back.
2.
The other person inserts the
door
support (A)
into the bottom hole of the
door.
3.
Use a Philips screwdriver to tighten the
screw.
CAUTION
To avoid personal injury or product
damage from a fall or scratch, use caution
throughout the entire process.
STEP 6
Initial settings
By completing the following steps, the refrigerator should be fully functioning.
1.
Plug the power cord into the wall socket to turn the refrigerator on.
2.
Open the door, and check if the interior light lights up.
3.
Set the temperature to the coldest, and wait for about an hour. Then, the freezer will be
slightly chilled, and the motor will run smoothly.
4.
Wait until the refrigerator reaches the set temperature. Now the refrigerator is ready
for use.
Untitled-2 30
2016-09-22 11:43:03