08_
setting up
08_
setting up
17.
Tighten the 3 bolts and then connect the wires
back together.
Make sure your freezer is unplugged before
handling electrical wires.
18.
Connect the wire on the plastic cover and put the
cover back to its original position.
19.
Tighten 2 screws back to its place.
20.
Detach the Fridge and the Freezer door gaskets
and then attach them after rotating them 180˚.
• After reversing the doors, make sure
the Fridge and Freezer door gaskets are
properly arranged. If not, there might
be a noise or dew formed which affects
perfomance of the refrigerator.
12.
Use wrench to separate the hinge shaft and then
fl ip the hinge and reattach the hinge shaft.
13.
Reassemble the hinge on the freezer door by
reversing the step 11. Make sure to use right side
hinge cover (which can be found underneath the
removed plastic cover from step 2) and remove
the grommet. After reassembling the hinge, wire
and the hinge cover, switch the side from left to
the right.
14.
After switching the hinge, make sure to take out
the right side wire cover, and close it with the wire
cover on the top of freezer door.
15.
Take off the handle cover and remove the screws,
make sure to detach the caps and the handle
from the right to left side of the door. (Make sure
to cover the right side with detached caps.)
Handles may not have cover depending on
the models.
16.
Switch the hinge cap and attach the front leg
cover. Carefully put the freezer door back on.
Grommet
Grommet
“Cover Wire Door R” can
be found in the packaging
Hinge cap
Hinge cap
WARNING
WARNING
DA99-01951G.indb 섹션2:08
DA99-01951G.indb 섹션2:08
2012.6.1 2:20:33 PM
2012.6.1 2:20:33 PM
Downloaded from Fridge-Manual.com Manuals
