English - 12
REVERSING THE FREEZER
DOOR
Samsung recommends that reversing of the
door opening is only completed by Samsung
approved Service providers. This will be on
a chargeable basis and at the customers
expense.
Any damage caused while attempting to
reverse the door opening is not covered
under the appliance manufactures warranty.
Any repairs requested due to this
circumstance will be completed on a
chargeable basis at the customers expense.
Required Tools (Not provided)
Phillips Head
Driver (+)
Flat Head
Driver (-)
10 mm
Socket Wrench
(for bolts)
8 mm
Socket Wrench
(for bolts)
Spanner
(for hinge shaft)
5 mm Hex
Wrench
(for bottom
hinge shaft)
WARNING
1.
Remove 4 screws on the top of the freezer.
2.
Remove the plastic cover and make sure to
disconnect the wire connected to it.
After removing the plastic cover, check the parts
for reversing the door.
Be careful not to damage the electrical wires
when removing the plastic cover.
3.
Disconnect the wires and then remove 3 bolts.
Make sure your freezer is unplugged before
handling electrical wires.
CAUTION
WARNING
DA68-03009C-05.indd 12
DA68-03009C-05.indd 12
2015. 5. 13.
9:46
2015. 5. 13.
9:46