English
35
Ins
tallation
CAUTION
When adjusting the length of the water line
tubing, make sure to smooth out the cut
surface at a right angle. This is to prevent a
water leak.
NOTE
This replacement process may involve the refrigerator to drip water onto the floor. If this
happens, wipe up with dry cloths.
STEP 6
Initial settings
By completing the following steps, the refrigerator should be fully functioning.
1.
Remove the PE foam sheet on each shelf corner, which is attached to protect the
refrigerator during transportation.
2.
Plug the power cord into the wall socket to turn the refrigerator on.
3.
Open the door, and check if the interior light lights up.
4.
Set the temperature to the lowest, and wait until the refrigerator reaches the set
temperature. Now the refrigerator is ready for use.
NOTE
When the refrigerator powers on, the alarm will sound. To turn off the alarm, tap any
button ( ,
OK
, or ).
STEP 7
Final check
When the installation is complete, confirm that:
• The refrigerator is plugged into an electrical outlet and grounded properly.
• The refrigerator is installed on a flat, level surface with a reasonable clearance from the
wall or the cabinet.
• The refrigerator is level and is sitting firmly on the floor.
• The door opens and closes freely, and the interior light turns on automatically when you
open the door.
Untitled-5 35
2022-10-20 3:51:55
