Attaching the Stand
(S24C366EA* / S24C368EA* / S24C369EA* / S24C36DEA* / S27C366EA* / S27C368EA* / S27C369EA* / S27C36DEA*)
֜
Before assembling the product, place the product down on a flat and stable surface so that the screen is facing downwards.
: The product is curved. Placing pressure on the product when on a flat surface may damage the product. When the product is on the ground facing up or down, do not put pressure on it.
֜
The exterior may differ depending on the product.
3
1
2
Place the protective Styrofoam (cushion) included in the package on the floor and
place the product facing down on the Styrofoam, as shown in the image.
If Styrofoam is unavailable, use a thick sitting mat.
Hold the back of the monitor as shown in the figure.
Push the assembled stand into the main body in the direction of the arrow as shown
in the figure.
Insert the stand neck into the stand base in the
direction shown in the figure.
Check that the stand neck is firmly connected.
Tightly fasten the connecting screw
at the bottom of the stand base.
4
5
Stand up the monitor and remove the package.
Stand assembly is complete.
Caution
Do not arbitrarily remove the panel film. If not observed, the warranty service may be
restricted.
