13
Additional Information:
When viewing a programme, pressing the info key will display the information banner.
Note:
If the receiver was previously working on a channel and the “No Signal” icon appears, you may have
one of the following problems:
Signal degraded heavily by poor weather
Channel no longer broadcasting and no carrier
was detected.
Dish not aligned to the correct satellite
LNB power switched off in the menu
Faulty cable or LNB.
The Signal and Data level meter:
Press the Signal key during view mode to display the signal
and data level for the current channel. Use this feature to
assist dish alignment or fault finding should there be a
reception problem.
Diagnostic Information:
For more information on the receiving signal,
press the INFO key to display the diagnostic
Screen:
The diagnostic screen displays detailed broadcast
information in real time. Press INFO key again to
return to the signal meters or ESC to return to
the
Picture.
Memory Status:
At any time you can check the memory status on you receiver.
The indicator shows the amount of receiver memory used by the stored channels.
Press:
Menu, Channel Setup, Memory Status
:
Memory Used
All channels are stored in memory
Memory Used
Signal
Data
Use INFO key for diagnostic info
.
Pic. Size:
544x576
Frames/Sec:
25.00
Asp. Ratio:
4:3
Bits/Sec:
15000000
Audio
Channel:
Stereo
Emphasis:
Off
Sample Rate:
48.00kHz
SAMSUNG
Signal
Data
Video
