Samsung SC-D362 Service Manual Download

Page: 126 / 244

Operating Instructions

11-4

Samsung Electronics

ENGLISH

Preparation

Lithium Battery Installation

Lithium Battery Installation for the Internal Clock

1. Remove the Battery Pack from the rear of the Camcorder.
2. Open the Lithium Battery Cover on the rear of the Camcorder.
3. Position the Lithium Battery in the Lithium Battery Holder, with the positive

(

) terminal face up.

Be careful not to reverse the polarity of the Battery.

4. Close the Lithium Battery Cover.

Lithium Battery Installation for the Remote Control (SC-D364/

D366

only)

1. Pull out the Lithium Battery Holder toward the direction of the arrow

using instruments such as a pair of tweezers.

2. Position the Lithium Battery in the Lithium Battery Holder, with the positive

(

) terminal face up.

3. Reinsert the Lithium Battery Holder.

Precaution regarding the Lithium Battery

1. The Lithium Battery maintains the clock function and preset contents of the memory; even if the Battery Pack or

AC Power adapter is removed.

2. The Lithium Battery for the Camcorder lasts about 6 months under normal operation from time of installation.
3. When the Lithium Battery becomes weak or dead, the date/time indicator will display <12:00 AM JAN.1,2006> when

you set the <Date/Time> to <on>.
When this occurs, replace the Lithium Battery with a new one (type CR2025).

4. There is a danger of explosion if Battery is incorrectly replaced.

Replace only with the same or equivalent type.

Warning: Keep the Lithium Battery out of reach of children. Should a battery be swallowed, consult a doctor

immediately.

CHG

QUICK
MENU

ENGLISH

Preparation

Using the Lithium Ion Battery Pack

Use SB-LSM80 or SB-LSM160 Battery Pack only.
The Battery Pack may be charged a little at the time of purchase.

Charging the Lithium Ion Battery Pack

1. Turn the [Power] switch to [Off].
2. Attach the Battery Pack to the Camcorder.
3. Connect the AC Power Adapter to an AC Cord and

connect the AC Cord to a wall socket.

4. Connect the DC cable to the DC jack on the

Camcorder.
The charging indicator will start to

blink

, showing that the Battery is charging.

Press and hold

the DISPLAY

button

while charging and the charging status will be

displayed on the LCD for 7 seconds.

6. When the Battery is fully charged, disconnect the Battery Pack and the AC Power Adapter

from the Camcorder.
Even with the Power switched Off, the Battery Pack will still discharge.

Charging, Recording Times based on Model and Battery Type

If you close the LCD Screen, it switches off and
the Viewfinder switches on automatically.
The continuous recording times given in the table
to the right are approximations.
Actual recording time depends on usage.
The continuous recording times in the operating
instructions are measured using a fully charged Battery
Pack at 77 ¡F (25 ¡C).
Even when the Power switched Off, the Battery Pack will still discharge if it is left attached to the device.

Blinking time

Charging rate

Once per second

Less than 50%

Twice per second

50% ~ 75%

Three times per second

75% ~ 90%

Blinking stops and stays on

90% ~ 100%

On for a second and

Error - Reset the Battery Pack and