12
– DIGITAL COLOR DOME CAMERA
Installation
U
•
•
•
•
•
H
Adjusting the camera direction
When the camera is
fi
xed on the ceiling, you can adjust the camera viewing angle.
You can rotate your camera leftward or rightward (Panning), and can change the
slope of your camera upward or downward (Tilting).
In case of panning, the rotation limit of your camera is set to 355 degree (100
degree clockwise and 255 degree counterclockwise). The rotation is stopped by
the
Stopper
inside of the camera. For panning control,
fi
rst unfasten two screws
located on the bottom and rotate in the direction you want, and then fasten them to
fi
x the camera.
In case of tilting, you can change the slope of your camera from zero to 90 degree.
However if the slope angle is under 17 degree, you can encounter a partial image
hide problem. To
fi
x the location after adjusting the tilting angle, use the
Tilt fi xing
screws
.
To adjust the focus and zoom of your camera, use the
Zoom lever
and
Focus
lever
. When you install the camera on the inclined ceiling or wall, you can rotate the
camera lens to see a correct direction image.
Panning
Tilting
Lens rotation
