ENGLISH
66
Tr o u b l e s h o o t i n g
s l o w
s l o w
s l o w
s l o w
s l o w
s l o w
fast
n o
the battery pack is almost discharged. Change to a charged one.
the battery pack is fully discharged.
Change to a charged battery.
When the remaining time of the
Prepare a new one.
tape is about 3 minutes.
the tape reached its end.
Change to a new one.
there is no tape in camcorder.
Insert a tape.
the tape is protected to
If you want to record,
release the protection.
the camcorder has some
1. Eject the tape.
mechanical fault.
2. Set to OFF.
3. Detach the battery.
4. Reattach the battery.
* If repeated contact local service.
moisture condensation has formed
see below.
in the camcorder.
2 M I N
TAPE END
TA P E
TA P E
DEW
C . E M G
D . E M G
L . E M G
R . E M G
Informs that...
A c t i o n
Display
B l i n k i n g
✤
If the camcorder is brought directly from a cold place to a warm place, moisture may condense inside the camcorder,
on the surface of the tape, or on the lens. In this condition, the tape may stick to the head drum and be damaged or
the unit may not operate correctly.
To prevent possible damage under these circumstances, the camcorder is furnished with moisture sensor.
✤
If there is moisture inside the camcorder, “DEW” is displayed.
If this happens, none of the functions except cassette ejection will work.
Open the cassette compartment and remove the battery.
Leave the camcorder for at least two hours in a dry warm room.
Troubleshooting
✤
Before contacting a service center, perform the following simple checks.
They may save you the time and expense of an unnecessary call.
Moisture Condensation
Self Diagnosis Display
