The phone starts beeping and flashes on the display
The battery pack is insufficiently charged. Replace the pack
and recharge it fully until the lamp on the charger turns green.
The audio quality of the call is poor
Check the signal strength indicator ( ) on the display; the
number of bars indicate the signal strength from strong
( ) to weak ( ).
Try extending the antenna, moving the phone slightly or
moving closer to window if you are in a building.
No number is dialed when you recall a memory location
Check that the numbers have been stored correctly, by using
the memory scan feature (See page 32).
Re-store them in the memory, if necessary.
If the above guidelines do not enable you to solve
the problem, take a note of:
The model and serial numbers of your phone
Your warranty details
A clear description of the problem
Then contact your local dealer or SAMSUNG
Authorized Service Center.
84
85
MAINTENANCE REQUIRED
is displayed
Make sure the phone is registered to use.
Nothing is displayed
Check that the battery pack has been charged and installed
correctly.
Check that the phone has been switched on (
PWR
button
pressed for more than one second).
You have entered a number but does not dial.
Have you pressed the
SEND
button?
Is the cellular phone service currently available (
SVC
displayed)?
Are you accessing the right cellular network (if the phone is
programmed for dual network use)?
Your party cannot reach you
Is your phone switched on (
PWR
button pressed for more
than one second)?
Are you accessing the right cellular network (if the phone is
programmed for dual network use)?
Your party cannot hear you speaking
Have you switched off the microphone (
MUTE
displayed)?
Are you holding the phone close enough to your mouth? The
microphone is located at the bottom of the phone.
Miscellaneous
Miscellaneous
Summary of Contents for SCH-370B
Page 48: ......
