SAMSUNG Proprietary-Contents may change without notice
6-13
Circuit Description
Command No.
Command SW Name
Description
(OP, AB, RB)
1) The AB (Input Argument Byte Number) values of these commands are used only in the manual test. In
automatic test mode, the AB is regarded as 0.
2) You can assign the value for these commands. If the AB value is assigned without argument, the test is
achieved with the value stored in EEPROM.
3) After you get a desired test value by performing these commands, if you want to save the value into
EEPROM, use T-SAVE-VAL-I command to store the test value into the corresponding position.
*OP: Operation Command Number
AB: Input Argument Byte Number
RB: Return Byte Number
*SAT 32, 33 are not operating in MSM2 CHIP test
*46 command is required in Rx, and Tx path test at AMPS mode.
097 (F7,4,0)
098 (FB,1,0)
099 (FC,3,0)
100 (20,0,0)
T_FM_TX_PWR_I
T_PCM_FORMAT_I
T_SND_VOC_CAL_I
T_SIO_TO_DM_I
Setting the volume for Power Level 2 - 7
Format Pulse Code Modulation
Control Sound
Write NV_SIO_I
