Loading originals and print media
_ 33
PRINTING ON SPECIAL PRINT MATERIALS
The machine can hold special sizes and types of print material, such as
postcards, note cards, and envelopes. Especially, it is useful for single page
printing on letterhead or colored paper.
Feeding the print material manually
• Load only one size of print media at a time in the tray.
• To prevent paper jams, do not add paper when there is still paper in
the tray. This also applies to other types of print media.
• Print media should be loaded face up with the side you want to print,
and the top edge going into the tray first. Place print materials in the
center of the tray.
• Always load only the specified print media to avoid paper jams and
print quality problems. (See "Selecting print media" on page 29.)
• Flatten any curl on postcards, envelopes, and labels before loading
them into the tray.
1.
Open the manual
tray.
2.
Load the paper with the side to be printed on facing up.
3.
When you print in application, start the print menu.
4.
Before you print, open printer properties.
5.
Press the
Paper
tab in printer properties, and select an appropriate
paper type.
6.
Select
Manual Feeder
in paper source then, press
OK
.
7.
Start printing in application.
Place the side to be printed facing up.
Envelope
Preprinted paper
Transparency
Punched paper
Card stock
Letterhead paper
Label
If you want to use an label, set the paper type to
Label
.
• If you are printing multiple pages, load the next sheet after first
page prints out. Repeat this step for every page to be printed.
• The settings you change remain in effect only while you are
using the current application.