4
5
English
Before you install the DVD-ROM drive, we strongly recommend that you make certain that
your set-up meets the system requirements listed below.
System Requirements
Install the drive in your computer horizontally, making sure that the Open/Close
button is on the right.
Installing the DVD-ROM Drive
1
Turn OFF your computer. Remember to verify the
configuration jumper on the rear of the DVD-ROM drive.
To install the drive, proceed as follows.
2
Remove the cover of your PC(main unit of the computer).
3
Remove the blank cover panel for the 5.25 inch unit in
which the DVD-ROM drive is to be installed.
4
Connect the DVD-ROM drive to the IDE interface and
power cables located inside your computer.
☛
Connectors are keyed so it is impossible to put them in an incorrect
position. Do not force the connectors, if they do not seem to fit.
5
Install the DVD-ROM drive into the unit and secure it with
mounting screws (recommended standard M3x6x4).
◆
Depending on your PC model, you may need to attach
guide rails to the drive, so that the drive is held firmly in place.
On the ground that the guide rails are parts of the computer,
if you don’t have these, please purchase separately.
◆
If you use screws that are longer than the recommended
standard, you may damage the drive.
6
Put the cover back on your PC.
Item
Description
Type of computer
Intel Pentium 166MHz, RAM 16MB(or higher) with an
IDE interface (or a 100% IBM-compatible computer)
Free expansion unit
5.25 inch
Disk space
100 MB minimum
Windows version
95 OSR2 (or higher)
Playback of DVD Video PC with Window95 OSR2
DVD-Video playback software and appropriate hardware
(MPEG2 card etc.)
❉
For further details, refer to the documentation that comes with DVD-Video playback software
Installing the Software
You can install the device driver for DOS or for Windows.
1
Turn on your computer and wait for it to boot.
7
Reboot your system.
Result:
◆
The computer restarts
◆
Both the device driver and MSCDEX are loaded.
6
When the Setup Completed screen is displayed, remove the installation floppy disk from the drive.
2
Insert the driver disk into a floppy disk drive (usually the A drive).
4
Run the program:
5
To...
Then enter...
Confirm the installation
Y
Exit without installing
N
Result: If you answer Y (Yes), the installation program automatically
◆
Creates a SAMSUNG directory on your hard disk,
◆
Copies the required softwares,
◆
Modifies the CONFIG.SYS and AUTOEXEC.BAT files.
3
If you are a...
Then...
DOS user
◆
Type a: at the DOS prompt.
◆
Press the RETURN key.
Windows user
◆
Access the File Manager.
◆
Click on the A icon.
Windows 95 user
◆
When you are in Windows 95, it is not necessary to
install Device Driver. Whereas, when you are in Dos
Mode of Windows 95, then install as follows.
Windows 95 user
◆
Click on MY COMPUTER icon.
Windows 95 user
◆
Click on the A icon.
If you are a...
Then...
DOS user
◆
Type CDSETUP after the a: prompt.
◆
Press RETURN.
Windows user
Double-click CDSETUP.EXE from the Windows
File Manager.
Windows 95 user
Double click on CDSETUP icon.
Result: The CD/DVD-ROM Setup Program dialog box is displayed.
SDR(Eng) 11/12/98 8:11 AM Page 3
