14_
overview
overview
Using the numeric buttons
CHANNEL 1–9
Press each button between 1 to 9. (8CH : 8)
CHANNEL 10
Press the [
0
] button or press [
+10
] button first, then press the [
0
] button again within 3 seconds.
CHANNEL 11–16
Press the [
0/+10
] button first, then press any number between 1 to 6.
Changing the Remote Control ID
1.
Press the [
ID
] button of the remote control and check the ID displayed on the DVR screen.
The factory default ID of the remote control is 0.
2.
Enter 2 digits of your selection in order, while pressing the system [
ID
] button.
3.
When ID input is done, press the system [
ID
] button again to check the setting.
M
If you want to change the remote control ID to 08: Press 0 and 8 in order while the system [
ID
] button is pressed.
Remote control's ID and DVR’s ID should be matched for proper operation. Refer to “
Remote Devices
”. (Page 51)
