46_
main menu
main menu
Setting the PTZ
To use Camera’s PTZ functions, ID and protocols of each camera and DVR should be matched.
For other settings, refer to the
<
Remote Device
>
settings. (Page
50
)
Using the mouse may help make setup easier.
1.
Use the up/down buttons (
▲▼
) in <
Device
> window to
move to <
Camera
>, and press [
ENTER
] button.
2.
Select <
PTZ
>.
A window of PTZ settings appears.
3.
Use direction buttons (
▲▼◄ ►
) to move to a desired
item, and select it.
1
Port : Select a port control method for the camera that is
connected to a channel.
You have two choices : <
RS-485
> and <
Coaxial
>.
For the <
Coaxial
> type, only SDR-5102 is supported.
1
ID : Set the ID of the connected camera of each channel.
You can easily setup by using the numeric buttons on the remote control.
1
Protocol : Set the protocol of the connected camera of each channel.
M
You can check the camera’s ID and protocol if you turn the camera off and on after connecting it to the DVR
.
For the <
Coaxial
> type, CCVC and PELCO-C protocols are supported.
For the <
Coaxial
> type, only SDR-5102 is supported.
4.
When the PTZ setup is done, press <
OK
>.
CH
Port
b
ID Protocol
1
RS-485
b
0
>
None
b
2
RS-485
b
1
>
None
b
3
RS-485
b
2
>
None
b
4
RS-485
b
3
>
None
b
5
RS-485
b
4
>
None
b
6
RS-485
b
5
>
None
b
7
RS-485
b
6
>
None
b
8
RS-485
b
7
>
None
b
Camera
PTZ
Camera
Previous/Next Page
OK
Cancel
