1-1 Safety Precautions
1-1
S820/S850
1 Specifications
1-1-1 Federal Communications
Commission (FCC) Radio
Frequency Interference
Statement
1-1-1(a) Warning
This equipment has been certified to comply with the
limits for a Class B computing device, pursuant to
Subpart J of Part 15 of FCC Rules. Only peripherals
(system input/output devices, terminals, printers,
etc.) certified to comply with the Class B limits may be
attached to this system. Operation with non-certified
peripherals is likely to result in interference to radio
and TV reception.
1-1-1(b) Information to User
This equipment generates and uses radio frequency
energy and if not installed and used properly , that is,
in strict accordance with the manufacturer's
instructions, it may cause interference to radio and
television reception. It has been type tested and found
to comply with the limits for a Class B computing
device in accordance with the specifications in
Subpart J of FCC Rules, which are designed to
provide reasonable protection against such
interference in a residential installation. However,
there is no guarantee that interference will not occur
in a particular installation. If this equipment does
cause interference to radio or television reception,
which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the
interference by one or more of the following
measures:
1
.
Re-orient the receiving antenna.
2
.
Relocate the system with respect to the receiver.
3
.
Plug the system into a different outlet so that
the system and receiver are on different branch
circuits.
4
.
Move the cables connected to the system to
minimize the interference.
5
.
Tighten all cable screws.
If necessary, the user should consult the dealer or an
experienced radio/televsion technician for additional
suggestions. The user may find the following booklet
helpful: "Something About Interference." This is
available at FCC local regional offices. Samsung
Electronics Co., LTD. is not responsible for any radio
or television interference caused by unauthorized
modifications of this equipment or the substitution or
attachment of connecting cables and equipment other
than those specified by Samsung Electronics Co.,
LTD. The correction will be the responsibility of the
user. Use only shielded data cables with this system.
1-1-2 Canadian Radio Interference
Regulations
This apparatus does not exceed the class B limits for
radio noise emissions set out in the radio interference
regulations of the Canadian Department of Commu-
nications.
Le prèsent appareil n'émet pas de bruits
radioèlectriques dépassant les limites applicable aux
appareils digitals de la classe B prescrites par le
réglement de brouillage radioélec trique dicté par le
Ministére des Communications du Canada.
1-1-3 Important Safety Instructions
Read all instructions.
1
.
Do not use this product near water .
2
.
Do not place this product on an unstable cart,
stand or table. The product may fall, causing
serious damage to the product.
3
.
Slots and openings in the cabinet are provided
for ventilation. To ensure reliable operation of
the product and to protect it from overheating,
these openings must not be blocked or covered
by a bed, sofa, rug or other similar surface.
This product should never be placed near or
over a radiator or heat register. This product
should not be placed in a built-in installation
unless proper ventilation is provided.
4
.
Do not place this product in a location where
the cord may be tripped on.
5
.
Select a work surface that is large enough to
hold the SENS 620 equipment and any
additional items required for your work.
6
.
Do not allow the battery to be exposed to direct
sunlight for extended periods of time.
7
.
Do not allow anything to rest on the power
cord.
