If you set up the public DDNS (dyndns.
com, no-ip.com, or changeip.com), it will
take approximately 30 to 60 seconds
to get the IP address for the host name
(URL) to be updated in the DNS.
To connect this product to an IP
router, you have to designate a port
for this product in the setup menu of
the router. This product has 4 ports for
TCP communication. To use the DHCP
function provided by the IP router to
allocate the dynamic IP to the product,
designate a port for the IP that has
been allocated by the IP router setup
menu. When using the IP router, it
is recommended to use the fixed IP.
For that purpose, set the IP address
and port number to be allocated to
the product, select
Static IP
in the
connection mode and enter the IP
address assigned to the IP router. For
more information about using the IP
router, see the user manual of the IP
router or contact the manufacturer.
Callback Settings
This configuration is used to forward the callback
messages to the IP where Smart Viewer is
running. When any alarm, motion, or video loss
events occur, the system automatically connects
to the corresponding DVR to show the callback
messages.
On/Off:
Off is default. To use the callback
function, choose
On
.
IP Address:
Use the
UP/DOWN
direction
buttons to set the TCP IP address of the PC
where Smart Viewer is running.
Port(UDP):
Use the
UP/DOWN
direction
buttons to set a port number ranging from
7900 to 7999. The number changes by 1. You
have to also set the port value in the Callback
Connection menu for Smart Viewer setup.
Retry:
Select a number ranging from 1 to 20.
The number changes by 1.
Transfer Alarm In:
Set it to
On
to display
alarms on Smart Viewer.
Transfer Motion Detection
: Set it to
On
to display motion detection events on Smart
Viewer.
Transfer Video Loss
: Set it to
On
to display
video loss events on Smart Viewer.
Transfer System Log
: Set it to
On
to display
system logs such as critical system failures.
CAUTION
Even if this function is set to
On
, any
callback message will not be created
unless the settings for alarm, motion
detection, and video loss are set in
Event Record.
To get the callback messages from
Smart Viewer, click
Callback
.
Transfer Picture Settings
You can configure the video size and quality for
transferring pictures.
Video Size
: Select any of CIF and Half D1.
Quality
: Select any of Very High, High,
Standard, and Low.
Web Viewer Port Setting
You can configure the port number for Web
Viewer.
The available ports are those from 80 through
60080
.
If you set the port number instead of
80(default), it is needed to type the port number
into the address bar of the Web browser.
(e.g. http://218.209.27.130:500)
05 MENU SETUP
menu setup _
35
On/Off
On
IP Address
192.168.001.010
Port(UDP)
7900
Retry
05
Transfer Alarm In
Off
Transfer Motion Detection
Off
Transfer Video Loss
Off
Transfer System Log
Off
Callback Settings
Cancel
OK
Video Size
CIF
Quality
Very High
Transfer Picture Settings
Cancel
OK
Port
080
Webviewer Port Setting
Cancel
OK
SHR-5162_Eng-C2~C9.indd 35
2007-8-3 11:03:16
