Signal strength
Call in progress
New text message
assembling and preparing
your mobile phone
Get started by assembling and setting up
your mobile phone for its first use.
Install the SIMor USIM card
Insert the ejection pin into the hole on the tray to loosen the tray.
Gently press the card into the tray to secure it.
• Ensure that the ejection pin is perpendicular
to the hole. Otherwise, the device may be
damaged.
• If the card is not fixed firmly into the tray, the
card may leave or fall out of the tray.
• Use only a nano-SIM card.
Charge the battery
Before using the phone for the first time, you must charge the battery.
1. Open the cover to the multifunction jack on the side of the phone.
2. Plug the small end of the travel adapter into the multifunction jack. Improperly
connecting the travel adapter can cause serious damage to the phone. Any
damages by misuse are not covered by the warranty.
3. Plug the large end of the travel adapter into a power outlet.
4. When the battery is fully charged (the [|||||] icon is no longer moving), unplug
the travel adapter from the power outlet.
5. Unplug the travel adapter from the phone.
6. Close the cover to the multifunction jack.
A b o u t th e l o w b a tte r y i n d i c a to r
When your battery is low, the phone will emit a warning tone and a low battery
message. The battery icon will also be empty and blinking. If the battery level
becomes too low, the phone will automatically power off. Recharge your battery to
continue using yourphone.
DRAFT, Not Final
Summary of Contents for SM-J327T
Page 35: ...D R A F T N o t F i n a l...