26
Installation Guide
Reinstalling an SMP Expansion Module and cover
After installing options in the SMP Expansion Module, you will need to reinstall the
SMP Expansion Module cover and reinstall the SMP Expansion Module in the server.
Complete the following steps to reinstall the SMP Expansion Module cover:
1.
Install the cover on the SMP Expansion Module:
a.
Set the cover on top of the expansion module.
b.
Extend the locking levers as shown in the illustration; then, let the cam on the
front of the cover fall into the cam opening on the SMP Expansion Module
circuit board.
c.
Release the locking levers and align the rear of the cover with the rear edge of
the circuit board.
d.
Press down on the cover until it snaps into place.
Locking levers
CAM opening
Summary of Contents for SmartServer 3840
