- 7 -
The Microwave Oven is supported by a special
bracket assembly (mounting system) supplied with
the oven. The bracket assembly must be mounted to
the wall with toggle bolts through the wall, and a lag
screw into a wall stud. After the bracket assembly is
installed, the unit can be slid over the two rails of the
bracket assembly. Two bolts are run down through the
cabinet bottom and into the oven case to pull the oven
up against the cabinet bottom.
NOTE
: For easier removal and personal safety it is
recommended that two people remove this
product.
CAUTION!
The mounting surface must be capable of support-
ing the cabinet load, in addition to the 59 pound
product, plus additional loads of up to 50 pounds or a
total weight of 109 pounds.
This product cannot be
installed to cabinet arrangements such as an island or
peninsula. It must be mounted to both a top cabinet
and wall.
VENT BLOWER
The vent or exhaust blower is located at the top
of the oven. It is shipped for vertical exhaust but
can be changed to rear exhaust or recirculating
(See installation instrustions on how to change
and/or blower section on how to remove).
COOKTOP LIGHTS
One 40-watt screw base incandescent bulbs are
located on the bottom between the two grease
filters. The bulbs are user replaceable by removing
one screw and lowering access cover. The bulbs
could be difficult to remove when replaced for the
first time. a silicone glue is used to secure them
during shipping.
OVEN LIGHT
A 40-watt screw base incandescent bulb is located
in the top of the oven cavity at the front.
It is user replaceable by removing the top grill
(2 screws. On the front of outer case.). The bulb
is then accessible by removing a metal cover (1
screw).
Mounting Plate
3-4 Installation
