NETWORK PTZ CAMERA
User Guide
76
Chapter 4. Using Web Viewer
◊
Digital In(Sensor) Setup
ö
S1: Sensor 1, S2: Sensor 2, S3: Sensor 3, S4: Sensor 4
Category
Description
Use.
Check to use a sensor.
Type
“Normal Open” and “Normal Close” are available choices when selecting the type for a
connected sensor.
4.2.3.3. Alarm Sensor
Configure the options to use the Alarm services by attaching a sensor to the camera.
◊
Digital Out(Relay/Alarm) Setup
Category
Description
Relay
Select a digital output (Relay1 or Relay2) when certain events are detected: sensor (S1~4),
motion detection (MD), or video analytics(VA).
For Dur (Duration), select a duration for which to activate a selected relay upon the
occurrence of an event.
Sequence
Mode
Preset : Performs Auto Run to a preset number in the NUM pane. (Refer to 4.2.2 PTZ Page.)
Swing : Performs Auto Run in a selected Swing mode. (Refer to 4.2.2 PTZ Page.)
Group : Performs Auto Run in a selected Group mode. (Refer to 4.2.2 PTZ Page.)
Tour : Performs Auto Run in a selected Tour Search mode. (Refer to 4.2.2 PTZ Page.)
Trace : Performs Auto Run in a selected Trace mode. (Refer to 4.2.2 PTZ Page.)
NUM
In the Preset mode, Number is used to set up preset numbers.
FTP
Check to transfer information about certain events to your FTP server: sensor (Sensor 1
~4), motion detection (MD), or video analytics(VA).